2026 ROME 240-994

2026

New

Double Offset Tandem Disk Harrow for use with tractors in the 325–500hp range. * Engine horsepower are suggested ranges and vary according to soil conditions and weight added to harrow. Per ASAE S290.1 – Width of cut will vary with gang angle and disk blade diameter. NOTE: This harrow requires hydraulic control. Two rear tractor hydraulic circuits required for harrow operation. Width of Cut (ft/in): 36'0" (11m), Number of Disks: 94, Transport Height (ft/in): 15'9" (4.8m), Transport Width (ft/in): 15'6" (4.7m), Weight Per Disk: 240 lbs / 109 kgs, Number of Bearings: 24, Net Weight: 22,000 lbs / 9,979 kgs. 9” (229mm) disk spacing; 1-5/8” (41mm) round axles; Equipped with self-aligning oil bath dual tapered roller bearings. FEATURES: • Four gauge wheel assemblies provide a consistent depth of penetration on all four gangs while providing accurate leveling. • Double offset tandem disk harrow series is ideally suited to provide excellent uniform tillage results in all plowing applications • Main frame and gang carriers constructed of tough high strength tubular steel, welded for maximum strength and durability. • Transport position allows for approximately 10” (254mm) of ground clearance with standard 24” (610mm) diameter disk blades. • Equipped with reliable, heavy duty, dual tapered 9” (229mm) self-aligning oil-bath gang roller bearings with cast housings. • Bearing wear plates help protect the bearing housing from wear caused by abrasive soils extending their service life and decreasing cost. • Up to 8” (204mm) depth of penetration. • Tapered gang assemblies mounted on rock flex standards. Standard Equipment: • 24” (610mm) diameter x 1/4” (6mm) thick, smooth (round) shallow concavity disk blades. • Heat treated alloy steel gang axles. • Heavy duty cast steel spacers. • Eight 12.5L x 15 – F1 highway service tires for easy plowing, turning, and transporting. • Heavy duty 8 bolt wheel hubs with 2 tapered roller bearings on each hub with moisture protection. • Tandem walking beam transport. • Four gauge wheel groups. • Hydraulic control group includes cylinders, hose holders, and hoses with fittings to reach rear of tractor. • Hardened pins and bushings on all pivot points. • Adjustable disk blade scrapers. • Rock flex standards. • Drawbar jack stand. Optional Equipment: • 24” (610mm) diameter x 1/4” (6mm) thick, cutout (notched) front and smooth (round) rear shallow concavity disk blades. • 24” (610mm) diameter x 1/4” (6mm) thick, cutout (notched) front and rear shallow concavity disk blades. • Rear hitch assembly. • Rear hydraulic group. • Heavy duty bearing wear plates with 1/4” (6mm) hard plate overlay. • Light group.