Year
2027
Manufacturer
Model
Condition
New
Stock Number
VD 843379
Description
Overview
This new Peterbilt Model 536 medium duty dump truck is a Class 6 chassis rated at 26,000 lbs GVWR, and its maximum axle ratings combined exceed 26K. It has a Beau Roc DCS model dump body measuring 11x36x42. The day cab sits behind a Peterbilt Aero 107" BBC SMC hood with an aluminum cab and a bright-finish hood crown. The wheelbase is 152.0 inches, cab to axle is 85.0 inches, cab to end of frame is 145.0 inches, and axle to back of cab is 68.0 inches. The cab, hood, fenders and roof are painted white with Axalta two-stage paint, and the frame is black. With PX-7 power and Allison Rugged Duty Series shifting, this single axle dump truck is built for local hauling and construction work.
Engine & Drivetrain
Power comes from a PACCAR PX-7 Performance engine rated at 325 HP at 2400 RPM, governed at 2600 RPM, with 750 lb-ft of torque at 1800 RPM. The engine meets 2024 emissions standards and is EPA emission and idling compliant. It runs on EMUX electronics architecture with the powertrain optimized for balance and a typical operating speed of 70 MPH. Maximum accelerator pedal vehicle speed and maximum cruise speed are both set at 64, and maximum PTO speed is 1400 RPM. The engine idle shutdown timer is enabled at 5 minutes, with an impending shutdown warning and a hot ambient automatic override.
A VGT exhaust brake adds braking control. Engine support equipment includes a Horton on/off fan clutch, a high efficiency cooling system, an 18.7 CFM air compressor, an engine-mounted air cleaner with an air restriction indicator, and a PACCAR fuel/water separator. The electrical system has a PACCAR 160 amp brushed alternator, a PACCAR 12V starter, and three PACCAR Premium 12V dual purpose batteries rated at 2190 CCA. It also has a low voltage disconnect system and a battery disconnect switch mounted on the battery box. Exhaust is a single RH side-of-cab system with a single-module DPF/SCR mounted RH under the cab, finished with an 18" tall, 5" diameter chrome curved-tip standpipe with clear coat.
The Allison 3000 RDS-P Gen 6 Rugged Duty Series transmission is set up in a 6-speed close ratio configuration. It has a TC-413 torque converter and a dash-mounted push button shifter. The transmission runs Allison primary shift schedule 1 and HS/RDS package 223, with auto neutral when the parking brake is set and neutral at stop. The transmission has LH-mounted PTO provisions, and transmission oil temperature shows in the digital cluster. Power goes to the rear axle through an SPL170 HD-XL driveline with one midship bearing.
Chassis & Axles
The frame uses 10-5/8" steel rails with a 5/16" rail thickness. The rails are zinc coated and anti-corrosion treated, with aluminum frame rail crossmembers and a heavy-duty 5-piece crossmember behind the cab. The end of frame is square without a crossmember, so the body builder can install one. The front axle is a Hendrickson Steertek NXT rated at 10,000 lbs with a 3.32" drop and Hendrickson wide track. Steering is Sheppard HD94 power steering with a frame-mounted reservoir. The rear axle is a Dana Spicer S21-172 single axle rated at 21,000 lbs, with a 5.57 ratio and a single drive axle differential lock with speed interlock. All axles run synthetic lubricant.
The truck has air disc brakes front and rear, PHP10 aluminum preset hubs and pad dust shields on both axles. It also has a 4S4M anti-lock braking system (ABS), a pneumatic park brake, an SBM valve and a self-returning dash-mounted brake hand valve. Air is handled by a Bendix AD-HF EP air dryer with a heater, coalescing filter and extended purge, feeding aluminum painted air tanks with pull cords and nylon chassis hose. Body connections are provided 5 feet behind the cab, and a 7-way socket is mounted at the end of frame.
Fuel is carried in a 70-gallon D-shaped polished aluminum tank under the cab on the LH side, with a polished non-slip step and polished tank straps. The small DEF tank (5.5 gallon) is mounted LH behind the cab and has a polished stainless steel cover. An aluminum space saver battery box with side access sits RH behind the cab, the DPF/SCR box has a diamond plate cover, and a non-slip aluminum cab entry step is mounted RH under the cab. Up front is a 3-piece steel aero bumper with a bright finish.
Suspension
The front suspension uses 10,000 lb mono-leaf springs with shocks, greasable front spring pins and 80 mm spacer blocks. In the rear, a lightweight Peterbilt Air Trac suspension rated at 23,000 lbs uses air springs with internal bumpers. A dash-mounted dump switch with an indicator light controls the suspension, and suspension load air pressure shows in the digital cluster. The cab rides on its own air suspension.
Cab & Interior
The cab has a ProBilt charcoal gray interior with a curved roof and a thermal insulation package. The driver gets a Sears high back, vinyl air ride seat with a RH armrest. The passenger seat is a Sears high back, vinyl non-air ride seat with a toolbox underneath. Both seats are black and have seat skirts, and the seat belts are orange. The cab includes:
A multi-function steering wheel with audio and cruise controls on a tilt/telescope column
High-visibility yellow interior grab handles, metal door kick plates and a textured, NFPA-compliant exterior grab handle
Power door locks and power windows, and a combination fresh air heater and air conditioner
A one-piece curved windshield, a 3-piece fixed rear window and dark window tint
A stainless steel outside sunvisor
Bright-finish Peterbilt Aero mirrors that are motorized and heated with integrated convex mirrors, plus a look-down mirror over the passenger door
A ConcertClass AM/FM/WB radio with 3.5 aux input, two speakers, Bluetooth phone and audio, and a USB port
Electric intermittent windshield wipers, a deep rear wall record/map pocket and an air horn mounted under the cab
Auto reset circuit protection, and global telematics hardware with SmartLinQ disabled
The 7" digital cluster displays brake application air pressure, suspension air pressure, transmission oil temperature, engine PTO hours, turbo boost and voltage. The speedometer reads in both MPH and KPH, and three additional dash switches are wired behind the dash. Lighting includes composite fender-mounted headlights with integral DRL, park, turn and side marker lights, five LED aero marker lights in chrome housings, and two Peterbilt fog lights recessed in the bumper. There are also self-canceling turn signals, two flush-mounted LED load lights behind the cab, and switches and wiring for a beacon/strobe and an additional load light. The truck comes with a UL-listed, HAZMAT-approved ABC fire extinguisher, a triangle reflector kit and a 107 dB backup alarm.
Body & Equipment
The Beau Roc DCS model dump body measures 11x36x42. It is built from 215,000 PSI 450 HB steel:
A 3/16" one-piece floor
A 1/8" one-piece formed front
1/8" one-piece molded diamond-style sides with a 3/16" box top rail
A 3/16" diamond-style tailgate
3/16" high quality steel longitudinals with inside gussets for strength
A 42" full cab shield protects the cab. The body is raised by an M-100-4.25-3 25-ton piston with a 25-ton install kit, and it has a safety body prop and a body stop limit. Body equipment includes:
An air gate and spreader chains
Painted 2x10 pine side boards and steps inside and outside
A Mountain Tarp electric tarp system
A 20-ton pintle hook plate with D-rings
Two LED stop/turn/tail lights in the rear posts, reflectors and a center light bar
Four LED strobe lights, two on the cab shield and two at the rear of the body
Mud flaps with brackets and a backup alarm
Tires & Wheels
The front tires are Bridgestone 16-ply 11R22.5 R273 Ecopia, and the four rear tires are Bridgestone 16-ply 11R22.5 M799. All tires are mounted on Alcoa 885657 22.5x8.25 high polish aluminum severe service wheels. The outer wheel surfaces are mirror polished and have a Dura-Bright finish front and rear.
Warranty & Protection
This truck carries Peterbilt Class 7 Standard Coverage for 1 year with unlimited miles/km. The PACCAR PX-7 engine has Standard Coverage for 3 years with unlimited miles and unlimited hours. Base emissions warranty coverage is 5 years/100K miles.