This 2018 Epiroc Smartroc D65 standard feed machine is a one-owner unit, It was in the local Epiroc Service Center for a month or so and now finally out, tested and ready to drill rock! The attached photos and videos were taken before it went into the shop for a full service, it has since had a few other photos taken after it's cleaning, and functionality check. All wear items have inspected and replaced as needed. It comes equipped with a 995 CFM x 435 PSI air compressor, rear support jack, rod changer, full automation controls if desired, dust collection/water mist system, and much more—see the factory build sheet under the service log for full details. The unit is set up to operate 4" x 16'6" drill tubes and also features a breakout table, lights, auto-lube, and more. When this units leaves the Epiroc Service center it will be more than ready for your drilling application. TOTALLY SERVICED BY EPIROC AND READY TO DRILL ROCK. Negotiable!
*Monthly payment stated above assumes a secured commercial use loan transaction available for highly qualified commercial loan applicants. Actual loan payment amount and terms may vary. Consumer financing not available for consumers residing in Nevada. Additional state restrictions may apply. Equal opportunity lender. Click here for more state licenses and disclosures. NMLS ID: 1857954. VERMONT RESIDENTS: THIS IS A LOAN SOLICITATION ONLY. CurrencyFinance IS NOT THE LENDER. INFORMATION RECEIVED WILL BE SHARED WITH ONE OR MORE THIRD PARTIES IN CONNECTION WITH YOUR LOAN INQUIRY. THE LENDER MAY NOT BE SUBJECT TO ALL VERMONT LENDING LAWS. THE LENDER MAY BE SUBJECT TO FEDERAL LENDING LAWS. CALIFORNIA RESIDENTS: Financing provided or arranged by Express Tech-Financing, LLC dba Currency pursuant to California Finance Lender License #60DBO54873
Your current browser cannot run our content, please make sure your browser is fully updated or try one of the browsers below.
Get Financing
